Verdugos and San Gabriel Foothills · sector 03
Viking Repair in Sierra Madre, CA
Viking repair in Sierra Madre, canyon houses with a limited approach.
Where the van stops decides the morning
Above the town the lanes tighten, places to turn run out, and a fair number of houses are reached by steps from a drive shared with a neighbour. None of that prevents the work. It only fixes the order of it, and whether the heavy end of the job happens in one trip or three. Settled on the phone, the visit turns up with a trolley suited to steps, boards for whatever the load crosses and the parts most likely to be wanted already in hand. Discovered at the door, the same repair spends half its time walking back to the vehicle.
Canyon grit in the ports
A kitchen near the mouth of a canyon gets wind that lifts dust up the street and in through anything left open. On a cooktop it collects in the ring of ports around a burner, and the burner reports it honestly: a ring lighting a beat late, a flame with a gap in it, or a low setting that will not sit steady. Lifting the caps once they are cold and brushing them dry, without poking anything into the openings, is owner territory and is frequently the whole of the cure. A burner that still misbehaves afterwards points at the ignition side, and that part belongs to us.
Booking a Sierra Madre visit
Tell Viking Repair HQ Los Angeles on (213) 320-7007 which street you are on, how far up it you sit and where a vehicle can reasonably stand. Then say what the machine does wrong and read out the model and serial from its rating plate. A visit costs a flat $89, covering the journey and the whole diagnosis, and that sum comes off the repair the moment you agree to it.
Reviews
What Los Angeles owners say
Calls in Silver Lake, Los Feliz, Studio City and Sherman Oaks.
4.9 / 5562 reviews
Whenever a pot boiled over, the front burners quit sparking for days afterwards. The electrode had cracked and was shorting through wet porcelain. New electrode, ports cleaned out, and he was gone inside an hour.
Nayeli B.Studio City
A grinding noise started behind the back wall whenever convection ran. The fan motor bearing had gone dry and was close to seizing. Ordered off the rating plate and fitted, quiet since. Four stars: it took eight days.
Boone T.Studio City
The undercounter unit at our pool bar quit cooling overnight. Gauges showed the charge was fine and the start relay was dead. Twenty minutes to find, one part, running before he packed up. No scare story.
Kenji B.Studio City
Book a visit
Book a visit in Sierra Madre
Sierra Madre is in sector 03, Verdugos and San Gabriel Foothills, and one desk books all six of them — say the street and what the machine is doing and it is in the diary.
Flat $89 to get someone out and the fault found · on site 8:00 am – 8:00 pm, seven days · desk answered 24/7
