Skip to content

East and North Valley · sector 02

Lake Balboa Viking Appliance Repair

Viking repair in Lake Balboa, single-storey ranches and somewhere to park outside them.

An easy approach changes what the van brings

Much of what makes a service call slow has nothing to do with the appliance. Stairs, a gate, a metered kerb and a long carry all decide what a technician is prepared to unload before the fault is even known. On these blocks none of that applies, so a visit begins with the trolley, the board protection and the heavier spares already at the door. In practice a machine that has to come out of its opening can be dealt with in one trip far more often here than it can on a hillside street above the boulevards.

Ordinary faults, read properly

Kitchens on this side of the basin are not unusual, and the work in them is the everyday run of built-in repair. What decides whether a job is short or returning is how carefully the machine gets read before a part is chosen. Meters on the circuit, the door followed along its whole seal, the airway behind the cabinet actually looked at: the unhurried half of a visit is the half that keeps the same call from coming back a month later. An easy address is precisely where there is room to do that properly.

Booking a Lake Balboa visit

Viking Repair HQ Los Angeles answers on (213) 320-7007; have the model and serial off the plate ready, along with a plain account of what the machine is doing. Say whether the driveway will be clear, because a van at the door saves the carry. You pay $89 for the visit and the diagnosis, and that amount is subtracted from the repair the moment you approve it.

Reviews

What Los Angeles owners say

Calls in Silver Lake, Los Feliz, Studio City and Sherman Oaks.

5.0 / 5767 reviews

  • A grinding noise started behind the back wall whenever convection ran. The fan motor bearing had gone dry and was close to seizing. Ordered off the rating plate and fitted, quiet since. Four stars: it took eight days.

    Boone T.Studio City

  • Half the griddle plate would not come up to heat for our Sunday breakfasts. A broken element leg and a scorched connector at the block, both replaced. It cooks flat now, but the part took nine days.

    Emiliano C.Sherman Oaks

  • Our built-in hummed loud enough to hear down the hall of a small hillside ranch, and the food was slowly warming. A worn evaporator fan bearing was both the noise and the cause. Swapped, two defrost cycles watched through.

    Ilan G.Sherman Oaks

Book a visit

Book a visit in Lake Balboa

Lake Balboa is in sector 02, East and North Valley, and one desk books all six of them — say the street and what the machine is doing and it is in the diary.

Flat $89 to get someone out and the fault found · on site 8:00 am – 8:00 pm, seven days · desk answered 24/7

Screws, hinge brackets, a roller pin and washers heaped on a cloth beside a wire brush, two Phillips drivers and pliers
What a door and latch rebuild looks like laid out