Skip to content

Eastside and Hollywood Hills · sector 01

Viking Repair in Eagle Rock, Los Angeles

Viking repair in Eagle Rock, Craftsman kitchens rebuilt around bigger equipment.

A Craftsman kitchen with a professional range in it

The usual Eagle Rock job is a Craftsman house whose kitchen has been opened towards the back of the plan and fitted out with equipment considerably heavier than the room was framed to carry. Timber floors, a tiled or plastered return along one side, and a range occupying the space a far lighter stove used to. There is nothing wrong with any of that, but it does dictate method: weight goes onto boards before the machine is moved at all, and the finishes either side are covered first, because a chipped tile or a scored plaster edge in a house of this age cannot be matched from stock.

Where the clearances run out

Clearance, rather than any single component, is the recurring difficulty. A worktop overhang that halts the machine as it comes forward, a cabinet return sitting a hand from the side panel, an opening narrower than the appliance that was once carried through it. The opening minutes of a visit are therefore spent measuring: how far the range will actually travel, whether its door needs lifting off the hinges, and what has to be cleared before anything passes. Settling that before a single lift keeps a repair from turning into joinery.

Booking an Eagle Rock visit

Ring Viking Repair HQ Los Angeles on (213) 320-7007, describe the room the machine stands in, and mention whether there is a tiled or plastered return hard against it. The numbers on the rating plate are worth quoting too, since they decide which spares ride out on the van. The $89 service call pays for getting here and for the diagnosis in full, and it is taken off the total the moment you approve the fix.

Reviews

What Los Angeles owners say

Calls in Silver Lake, Los Feliz, Studio City and Sherman Oaks.

4.9 / 51,312 reviews

  • Flames were lifting off two burner caps and burning orange, which frightened me. Fine grit blowing down off Griffith Park had packed the ports and one cap sat crooked. Cleared and reseated, blue flame again.

    Shoshana P.Los Feliz

  • The undercounter unit at our pool bar quit cooling overnight. Gauges showed the charge was fine and the start relay was dead. Twenty minutes to find, one part, running before he packed up. No scare story.

    Kenji B.Studio City

  • Ours would not start at all, though the panel lit up as though nothing was wrong. The door latch switch had failed, so it never saw the door as closed. Replaced, and it starts on the first touch.

    Lila K.Sherman Oaks

Book a visit

Book a visit in Eagle Rock

Eagle Rock is in sector 01, Eastside and Hollywood Hills, and one desk books all six of them — say the street and what the machine is doing and it is in the diary.

Flat $89 to get someone out and the fault found · on site 8:00 am – 8:00 pm, seven days · desk answered 24/7

Stripped latch hardware — bracket, spring, ceramic insulator and a small bearing — on a cloth beside a nut driver and pliers
Latch parts already off the machine